A/C & heater controls

Faults and Technical chat for the Nissan Pulsar
Post Reply
Gilly
Posts: 3
Joined: Mon Mar 25, 2019 7:25 pm

A/C & heater controls

Post by Gilly » Mon Mar 25, 2019 7:36 pm

Hi Guys new to the forum but need some advice.
I have a 2015 1.2 Tekna pulsar.
I had a fault with the battery which was changed. I'm not sure if this is related but after that the heater will not change blower direction and the temp does not change.
I have checked the usual culprits like fuses relays etc with no fault found.
Before I get into the main components I thought I would ask to see if anybody else had this problem.
Thanks in advance
Andy


Swe
Posts: 80
Joined: Sun Nov 06, 2016 10:37 am
Location: Sweden

Re: A/C & heater controls

Post by Swe » Mon Mar 25, 2019 9:05 pm

After battery replacement the computer must be programmed, is this done??
:shock:


Gilly
Posts: 3
Joined: Mon Mar 25, 2019 7:25 pm

Re: A/C & heater controls

Post by Gilly » Wed Mar 27, 2019 6:22 am

No!
Is this something which I can do or does it need to go to a dealer?


Swe
Posts: 80
Joined: Sun Nov 06, 2016 10:37 am
Location: Sweden

Re: A/C & heater controls

Post by Swe » Wed Mar 27, 2019 7:14 am

You need programming tools, should recommend you to do it at a Nissan workshop and get help if acc problems remains after programming.
:shock:


Gilly
Posts: 3
Joined: Mon Mar 25, 2019 7:25 pm

Re: A/C & heater controls

Post by Gilly » Wed Mar 27, 2019 8:24 am

Thanks for the help.


stiyo
Posts: 16
Joined: Wed Aug 01, 2018 10:07 am

Re: A/C & heater controls

Post by stiyo » Wed Mar 27, 2019 2:11 pm

Last time when i change myself the battery, i don't need any programming tools. After the new battery is installed, i can start the car right up without the need to set anything up. I just lost the logs of CO2 saving, average fuel and lowest fuel consommation but not an important things.

If the programming tools is the OBD reader, then yes, you just need to clear the fault up since you've said there was a fault. Did the fault was mentioned somewhere?


Post Reply

Return to “Faults & Technical”