2DIN radio for Visia model

All Nissan Pulsar related discussions
syneman
Posts: 99
Joined: Thu Aug 09, 2018 9:45 pm

Post by syneman »

I think I get one you mean, but you need to cut a line between the AC control section and the radio area. Maybe try to post a close up of yours. It will explain it all in a photo. Cheers!

MarcinJ
Posts: 27
Joined: Sun Aug 11, 2019 5:34 pm

Post by MarcinJ »

Hope this helps.

20191123_184242.jpg

20191123_184205.jpg

20191123_184155.jpg

20191123_184234.jpg

20191123_184228.jpg

20191123_184146.jpg

syneman
Posts: 99
Joined: Thu Aug 09, 2018 9:45 pm

Post by syneman »

Yes, That's a great job Marcin! I see I think you cut the panel, like you said with the Dremel, above the AC controls.
Thanks!!
MarcinJ
Posts: 27
Joined: Sun Aug 11, 2019 5:34 pm

Post by MarcinJ »

Exactly - cut the digital ac panel out to make place for the manual ac panel.
syneman
Posts: 99
Joined: Thu Aug 09, 2018 9:45 pm

Post by syneman »

MarcinJ wrote: Sat Nov 23, 2019 9:15 pm Exactly - cut the digital ac panel out to make place for the manual ac panel.
Yes, but have to make a perfect cut and measurement on both pieces. Best would be some laser cut.
MarcinJ
Posts: 27
Joined: Sun Aug 11, 2019 5:34 pm

Post by MarcinJ »

Yes, "The Perfect Cut". That's why I started with a prototype. My initial thought was to make the gap slightly larger and fill it with some ambient light but it ended being filled with a 1mm or less carbon flat bar.
syneman
Posts: 99
Joined: Thu Aug 09, 2018 9:45 pm

Post by syneman »

Ok..Thanks again for your great help and input !
MarcinJ
Posts: 27
Joined: Sun Aug 11, 2019 5:34 pm

Post by MarcinJ »

No problem. I wish you luck in completing this project. It's worth it.
Post Reply